Clamp-All Couplings are quick and easy to install.  Simply follow the instructions noted below.  

Step 1 - The cut ends of the pipe should be smooth and square.

Step 2 - Place neoprene gasket on end of pipe or fitting until it is firmly seated against the center stop.

Step 3 - Place stainless steel housing with clamps on end of other pipe and slip the pipe into the gasket until it is also firmly seated against the center stop.

Step 4 - Slide the housing into position directly over the gasket.  Using preset torque wrench, alternately tighten clamps to  torque required by model.  Recheck torque on all clamps before proceeding to next installation to assure an even and proper torque.

Hanging

Hubless Cast Iron Soil Pipe and Fittings joined by Clamp-All Couplings may be hung with one hanger per length where allowed by code.

Vertical Piping shall be supported at each stack base and at each floor.  Free standing vertical pipe should be adequately staked or braced during construction to maintain alignment in accordance with local codes.

Horizontal Piping shall be supported within 24 inches of the coupling joint at 10 foot intervals for 10 foot lengths of pipe and at 5 foot intervals for 5 foot lengths of pipe and at every third fitting where they are contiguous.  Supports or hangers should be properly placed to maintain alignment and grade with provision made to prevent shear  Horizontal runs of pipe 5" diameter and larger must be braced at changes of direction and sway braced as necessary to prevent horizontal movement and maintain alignment..

Installation of Clamp-All couplings must be in accordance with our printed installation instructions and in conformance with local code requirements.

Pre-set Torque Wrench

Clamp-All manufactures Pre-set torque wrenches and requires their use for proper installation 

For proper installation of Clamp-All HI-TORQ 80 Couplings use Part Number 99080 & 99125 Torque Wrench

For proper installation of Clamp-All HI-TORQ 125 Couplings use Part Number 99080 & 99125 Torque Wrench

Clamp-All Products

2430 East Walton Blvd.

Auburn Hills, MI  48326

Tel:  800-762-7255

Fax: 248-373-3068

E-mail:  rantonishek@breezeindustrial.com